Project Octane Part 9

Update time for the wiring, finally got the 24 pin finished and the shroud installed this week.

Comnponents have been installed for a test fit, I have all the wiring to tidy up once everything is in place.

I didnt even test fit the shroud before gluing it all up, confident that my measurements were right. To get the shroud into the case, with the 8 pin GPU wiring pre installed meant removing the top panel and removable radiator tray then slotting it in from the top. I have removed one of the be quiet! basement covers to get the wirting through to get to the PSU.

[​IMG]
[​IMG]

Next up was to tackle the 24 pin, I had a small issue with the install and BitFenix were good enough to send out a replacement cable, meaning that I installed this whilst in the case.

[​IMG]
[​IMG]
[​IMG]

To gain access I removed the front panel to feed the cables through, as you can see, space is a bit tight here.

[​IMG]
[​IMG]
[​IMG]
[​IMG]
[​IMG]
[​IMG]

So now they are all in place they will need tidying up to make them perfectly straight with my custom combs. This is gettting close to finish now, just one more plate to make to cover the pre-exisitng cable holes then its on to vinyls.

Leave a Reply

Your email address will not be published. Required fields are marked *